Tamiya T3-01 12mm Hex Wheel Hub Adapter 7mm Offset - T301-02 by 3Racing  [T301-02]

12mm Hex Wheel Adapter for T3-01

This hub adapter is supplied as an aftermarket part for the Tamiya T3-01 chassis, offering a 12mm hex connection and a 7mm offset to reposition the wheel. It is intended to make measured changes to track width and scrub radius to assist handling setup.

Installation is aimed at seasoned hobbyists: remove the wheel and factory hub, locate the 12mm hex hub onto the T3-01 axle or stub, and secure using the existing wheel nut or retaining hardware. After fitting, check for clearance issues near the suspension and body and confirm wheel runout and nut torque after an initial short run.

Apply this hub when you need subtle wheel placement changes to influence corner balance, reduce uneven tyre wear, or adjust steering geometry. It is an accessory for tuning and should be checked for fit and security before each session.