TAMIYA T3-01 Rear Shaft and Aluminium Hex Adapter +2mm - T3023SR/+2MM by GPM  [T3023SR/+2MM]

Replacement rear shaft for the T3-01

This aftermarket assembly upgrades the stock rear drive components on the TAMIYA T3-01 DANCING RIDER with a stainless steel shaft and aluminium hex adapters suitable for hobby use. The kit transmits torque from the rear gearbox to the wheels and increases rear track by 2mm when installed.

The single-piece stainless steel shaft is chosen to reduce bending and wear compared with split or thin original parts, and the aluminium hex adapters are sized to work with the standard wheel hubs. Screw shafts and stainless locknuts are included to secure the assembly and help eliminate slack under load.

Fitting guidance: the shaft assembly connects with the chassis rear gearbox output and the standard T3-01 wheel hubs. Make sure threads are clean, install the supplied screws and locknuts to achieve correct preload, then check wheel runout after installation and again after a short trial drive.

Handling impact: this set is aimed at delivering a firmer drivetrain connection with a modest track increase to affect cornering balance; it is suitable for hobby-level tuning and improved drivetrain durability on the T3-01 platform.

Recommended when you need a direct, durable replacement for the T3-01 rear shafts and when a +2mm track change is part of your setup; re-check fasteners after initial runs to ensure everything remains secure.