TAMIYA Thunder Dragon / Thunder Shot Aluminum Rear Shock Tower - JR-TSD02-GU by Jazrider  [JR-TSD02-GU]

Tamiya Thunder Dragon/ Thunder Shot Aluminum Rear Shock Tower (Gun Metal)
Price:
£7.43
Brand:
JAZRIDER
Model:
JR-TSD02-GU
Condition:
Brand New
Available in shop
Write a review

Aluminium rear tower for TAMIYA Thunder Dragon and Thunder Shot

The JR-TSD02-GU aluminum rear shock tower is an aftermarket component designed for TAMIYA Thunder Dragon and Thunder Shot 1/10 buggies. Machined in a gun metal finish, it provides a firmer and more consistent mounting location for the rear shocks and additional mounting options for tuning.

Fitting generally requires removing the stock tower, aligning this tower with the chassis holes, and fastening with the original or appropriate screws. This item is intended for model use and does not indicate OEM supply.

As a tuning piece the tower changes shock geometry and supplies repeatable mounting points to fine tune ride height and damping balance. Make measured adjustments on track to assess the effect on handling rather than assuming direct improvement.

Is this compatible with aftermarket chassis variants?

Compatibility is with the stock mounting pattern of Thunder Dragon and Thunder Shot. If you are using a modified or third-party chassis, compare JR-TSD02-GU mounting hole positions before purchase.

Will aluminum cause extra wear on mounts?

Aluminum provides rigid support but can concentrate loads; check fastener torque and inspect mounts after initial runs to ensure no stress damage occurs to the chassis mounting points.

Any setup tips when changing tower position?

When you change shock eye positions, pair that with spring rate and damper adjustments. Make one variable change at a time and record lap times or feel to determine the net effect.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved