Designed for use on Tamiya Thunder shot, Thunder Dragon, Fire Dragon and Terra Scorcher chassis, this red two-piece aluminum adapter replaces the wheel mounting contact point to provide a reliable metal surface for wheel placement and setup tasks on 1/10 buggy platforms.
Application notes: the adapter functions as the direct wheel interface on the listed Tamiya models to improve consistency of wheel seating and reduce play found in aging plastic hubs. It is intended as a setup and alignment upgrade rather than a motor or drivetrain replacement.
Simple installation: remove the wheel and stock hub following chassis instructions, fit the adapter onto the axle or hex stub as needed for your hub type, retain using the original wheel nut or screw, and verify free rotation and runout before driving. Inspect and re-tighten fasteners after the initial test session.
When to use: the adapter is useful when swapping wheel types, checking offsets or seeking a repeatable metal mating surface for bearing seating during precision setup work on Tamiya buggy builds.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
