TAMIYA TL-01/GF-01/WR-02 Compatible Aluminum Rear Upper Suspension Arm - JR-TL101-BK by Jazrider  [JR-TL101-BK]

Tamiya TL-01/GF-01/WR-02 Aluminum Rear Upper Suspension Arm (Black)
Price:
£4.83
Brand:
JAZRIDER
Model:
JR-TL101-BK
Condition:
Brand New
Available in shop
Write a review

Product overview — rear upper suspension arm

This aluminium rear upper suspension arm is produced as a drop-in replacement for the TAMIYA TL-01, GF-01 and WR-02 chassis. Finished in black, it replaces the OEM plastic arm and installs above the rear hub carrier as part of the upper linkage.

The arm helps retain rear wheel alignment, control camber shift and influence roll-center placement within the rear suspension geometry. Aluminium construction reduces flex at mounting points and enables a more repeatable geometry during dynamic loads, aiding consistent handling across runs.

Installation typically involves removing the rear hub carriers and swapping the arm while verifying ball-stud and pivot clearances. Confirm that mounting holes and studs seat correctly without binding and check for smooth articulation through the full suspension travel. Standard service checks such as thread engagement and fastener security are recommended after fitting.

Compatibility

  • TAMIYA TL-01
  • TAMIYA GF-01
  • TAMIYA WR-02

How can I confirm this will fit my WR-02 setup?

Check the upper arm mounting layout on your hub carrier and compare hole spacing to the replacement arm. The part is intended for WR-02 geometry, but a dry fit before final assembly avoids surprises.

Are ball-stud or spacer changes ever required?

Most installs are direct; however, if your model uses non-standard ball-studs or spacers, verify clearance and adjust hardware to prevent binding.

Will this work with other TAMIYA suspension upgrades?

The arm is compatible with typical TL-01/GF-01/WR-02 upgrade paths, but check combined part geometries when mixing aftermarket pieces to ensure no interference.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved