TAMIYA TL-01/GF-01/WR-02 Front Upper Arm Upgrade TL01-13300-RD by Jazrider  [TL01-13300-RD]

Tamiya TL-01/GF-01/WR-02 Aluminum Front Upper Suspension Arm (Red)
Price:
£4.31
Brand:
JAZRIDER
Model:
TL01-13300-RD
Condition:
Brand New
Available in shop
Write a review

Precision front upper arm for TAMIYA models

This front upper suspension arm is machined from aluminum for use on TAMIYA TL-01, GF-01 and WR-02 chassis. The anodized red finish replaces the plastic original with a durable alloy unit while keeping the original attachment points and geometry.

The component preserves factory ball stud and hinge pin positions, acting as the upper link in the suspension assembly. Aluminum construction increases rigidity compared with plastic arms, which can change steering characteristics and should be considered when tuning handling.

Fitment is intended for direct replacement on compatible chassis. Before completing installation, verify clearance around the shock tower and steering linkages, ensure ball studs are seated properly, and confirm there is no interference with servo horns or tie rods. Inspect and reuse original fasteners only if they match the new arm and are in good condition.

Model fit list

  • TL-01
  • GF-01
  • WR-02

Which TAMIYA models will accept this arm?

The arm is made to the TL-01 family mounting pattern and will fit TL-01, GF-01 and WR-02 style chassis that use the same upper arm footprint; confirm your chassis layout prior to fitting.

Will the arm require different ball studs?

It uses the standard ball stud and hinge pin arrangement. Check that existing ball studs seat flush; if not, replace with matched hardware to avoid play.

Is extra corrosion protection needed?

The red anodize provides basic surface protection, but in coastal or wet conditions occasional cleaning and inspection will help prevent long-term corrosion issues.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved