Tamiya TL-01/GF-01/WR-02 Rear Lower Suspension Arm JR-TL103-BK by JAZRIDER  [JR-TL103-BK]

Tamiya TL-01/GF-01/WR-02 Aluminum Rear Lower Suspension Arm (Black)
Price:
£7.77
Brand:
JAZRIDER
Model:
JR-TL103-BK
Condition:
Brand New
Available in shop
Write a review

Replacement aluminium rear lower arm for Tamiya models

This aluminium rear lower suspension arm is supplied as an aftermarket replacement for Tamiya TL-01, GF-01, and WR-02 chassis that share the same mounting layout. The single-piece aluminium construction is intended to provide a sturdy direct-fit option where compatible.

As an aluminium upgrade, the arm offers a different stiffness and wear profile than many original plastic parts and is intended to be used with the chassis' existing mounting points and common hardware. Trial fitting with the model's screws and pins is recommended.

Use this arm to fine-tune rear response and improve repeatability over long use. After installation, confirm full suspension articulation and check for any interference with other components to avoid binding.

Which Tamiya models will accept this arm without modification?

The arm is intended for TL-01, GF-01, and WR-02 layouts that use the same rear lower arm mounting pattern. Verify your chassis' rear mounting points match those models for a direct replacement.

Should I expect any clearance issues after fitting?

Clearance should be the same as the original if the chassis geometry is unchanged. Check suspension travel and inspect for rubbing at full compression to be certain.

Is any special maintenance required for an aluminium arm?

Inspect aluminium arms for wear at pivot areas and ensure threads or bushings remain in good condition. Replace worn pins or fasteners as needed to maintain secure fitment.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved