TAMIYA TRF 415 Machined Aluminium Suspension Mount (1D) 415-01/1D/V2 by 3Racing  [415-01/1D/V2]

Machined 1D Ver 2 suspension mount for TRF 415

This option replaces the factory suspension mount on the TAMIYA TRF 415 chassis with a machined aluminium 1D Ver. 2 component. It is designed to offer a more rigid pick-up point for the TRF 415 suspension while conserving original attachment locations.

Fitting is simple for those experienced with basic RC work: remove the standard mount and secure the aluminium unit in the same positions. Use the supplied or original fasteners as appropriate, and verify free suspension movement before final tightening to prevent binding. No additional fittings are included unless the listing specifies otherwise.

During tuning, aluminium alters the stiffness at the mounting points compared with plastic, which can change how suspension geometry behaves under load. Install this mount when you require a stable baseline for setting shocks, camber, and roll centre on the TRF 415 chassis.

Maintenance is minimal: check for burrs after installation, keep fixings tight, and watch the finish for wear after frequent testing. This item is intended solely for RC use on the TRF 415.