Tamiya TRF 415 Titanium hardware kit TS-415/V1 by 3Racing  [TS-415/V1]

Tamiya TRF 415 Titanium Screw Set - 3RACING TS-415/V1
Price:
£20.41
Brand:
3Racing
Model:
TS-415/V1
Condition:
Brand New
Write a review

TRF 415 titanium screw kit description

This titanium screw set is made for the Tamiya TRF 415 chassis and matching TRF 415 components. The fasteners are selected to lower weight and improve corrosion resistance versus conventional alloy steel screws, supporting careful assembly and precise setup adjustments for competitive running.

The product suits hobbyists who routinely assemble and tune 1/10 tourers; installation needs the correct hex drivers and light, controlled torque so as not to damage fine threaded parts. Use these screws on critical mounting points such as shock towers, suspension brackets, and chassis joiners where titanium's benefits are desired.

When changing hardware, verify each screw against the original for both thread and length, and avoid over-tightening. If using threadlocker, pick a product made for model-scale use and apply in small amounts only where necessary.

Specifications

  • Item: Titanium screw set
  • Material: Titanium
  • Model Number: TS-415/V1
  • Compatibility: Tamiya TRF 415 chassis

A targeted upgrade for TRF 415 owners looking for lighter, more corrosion-resistant fasteners to aid precision assembly and track setup; adhere to standard RC fitment practices when replacing stock bolts.

Do these screws fit the TRF 415 straight away?

They are specified for the TRF 415, but always match thread size and length to the original screws before final assembly to ensure correct fit.

Is special maintenance needed for titanium hardware?

Routine checks are sufficient; titanium resists corrosion but you should still inspect fasteners after crashes and confirm torque after initial runs.

Will these screws interfere with electronics or grounding?

Titanium is nonmagnetic and electrically different from steel; for grounding-sensitive setups, follow your component makers guidance and avoid changing electrical paths unintentionally.

Can I mix these with original steel fasteners?

Yes, but check each position for required length and thread. Keep critical load points matched to recommended hardware and use titanium where corrosion resistance or reduced mass is desired.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved