Tamiya TT-01 10mm Bronze Ball End Upgrade for Upper and Lower Arms TT007 by GPM  [TT007]

Tamiya TT01 Bronze 10mm Ball For Up/Lower Arm set - GPM TT007
Price:
£2.88
Brand:
GPM
Model:
TT007
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

10mm bronze ball end upgrade for TT-01

This compact upgrade set is made for Tamiya TT-01 models and supplies 10mm bronze ball ends for the upper and lower control arm connection points. It is intended to replace worn plastic parts and restore accurate linkage movement without altering the chassis geometry.

Fitting is straightforward for anyone familiar with arm removal: remove the relevant arm, install the bronze ball ends into the ball cups and secure following the chassis manual. No specialised equipment is required beyond standard hobby tools.

Bronze contact surfaces reduce free play seen with plastic ball ends, helping to stabilise steering feedback and create more predictable suspension reactions when adjusting roll-steer or camber on the TT-01.

Will these fit a tuned TT-01?

They will fit TT-01 variants that retain 10mm ball end locations on the upper and lower arms. Check your specific arm design and ball cup size before purchase.

Do they need locking compound or threadlocker?

Follow the chassis service guidance for fastener security. In many cases standard assembly without additional compounds is fine, but use threadlocker where the manual recommends it.

Are these worth fitting for handling?

Yes, for drivers seeking more consistent steering feedback and reduced slop, bronze ball ends are a practical upgrade for better repeatability during setup and laps.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved