Tamiya TT-01 Rear Aluminium Hub Carrier 3 Degree TT01-12/3/LB by 3Racing  [TT01-12/3/LB]

Rear hub carrier for TT-01 chassis

This aluminium rear hub carrier fits 1/10-scale Tamiya TT-01 and TT-01 TYPE E chassis and provides a permanent 3-degree rear camber to assist chassis setup. It is supplied as an RC replacement intended to work with the original rear suspension pieces.

Fabricated in aluminium, the carrier serves as the mounting point for the rear hub and suspension link attachments and provides a firmer interface than standard plastic carriers, improving repeatability under load.

Fitting notes: confirm compatibility with your TT-01 or TT-01 TYPE E layout before installation, reuse the existing fasteners and wheel bearings unless you plan separate upgrades, and check wheel alignment and drive-shaft engagement after fitting. No additional hardware is assumed to be included with the part.

Setup impact: the fixed 3-degree camber changes tyre contact geometry under load which can affect handling balance and tyre wear; incorporate this change into small, successive setup adjustments to achieve the desired behaviour.