TAMIYA TT01/TT01E Compatible Upper Rear Suspension Arms, Red Anodized - JR-TT105-RD by Jazrider  [JR-TT105-RD]

Tamiya TT01 / TT01E Aluminum Rear Upper Suspension Arms (Red)
Price:
£7.88
Brand:
JAZRIDER
Model:
JR-TT105-RD
Condition:
Brand New
Available in shop
Write a review

Briefing on the rear upper suspension arm

The Jazrider JR-TT105-RD rear upper arm is an aftermarket part made for the TAMIYA TT01 and TT01E chassis. Manufactured from anodized aluminum with a red finish, these arms offer a more rigid mounting point than standard plastic arms, improving camber retention and reducing roll under load.

Offered as a direct-fit upgrade for model builders, the component supports small setup changes and tuning of suspension geometry. It impacts how forces transfer through the upper rear link area during acceleration, braking, and cornering, enabling fine adjustments to handling without changing primary chassis pieces.

Fitment advice: install using original hinge pins and mounting hardware from your TT01 or TT01E, check body and shock tower clearances after fitting, and verify wheel alignment prior to running. Regular inspections following test sessions are advised to keep fasteners secure.

Will these arms run with my existing TT01 setup?

Yes, JR-TT105-RD is designed for the TT01 and TT01E upper rear positions. After fitting, confirm hinge pin alignment and that the arms move freely through the intended travel.

Do I need to change shock or body parts when fitting these?

Most installs will not require new shocks or body parts, but you should inspect shock tower clearance and inner body mounts to ensure there is no contact throughout suspension travel.

Are any alignment checks recommended after installation?

Yes. Perform a wheel alignment and a short test run to check handling. Re-check fastener torque after the first session and adjust toe or camber as needed to suit the aluminium arms.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved