TAMIYA TT02/TT02B Replacement Prop Shaft Gear TT2100/G2 by GPM  [TT2100/G2]

Tamiya TT02B Steel Propeller Shaft Gear - 1pc (For TT02 / TT02B) - GPM TT2100/G2
Price:
£5.84
Brand:
GPM
Model:
TT2100/G2
GTIN:
4894538216189
Condition:
Brand New
Write a review

Prop Shaft Gear for TT02/TT02B Platforms

This steel propeller shaft gear fits the TAMIYA TT02 and TT02B series and is sold under the part reference TT2100/G2. It is intended as an RC-scale replacement to retain centre driveline engagement without altering motor or gearbox specification.

The steel build improves durability over softer stock components and is well suited to routine servicing, practice laps and tuning where drivetrain reliability is a priority.

Fitment advice: remove the drive shaft unit following your chassis instructions, inspect adjacent spur and pinion teeth and bearing condition, swap in the gear and set mesh and backlash before a low-speed test. Supplied as 1pc for model chassis maintenance.

Compatible Models

  • TT02
  • TT02B

Do I need new bearings when fitting this gear?

Not necessarily. Inspect existing bearings for play or roughness and replace them only if worn to ensure correct operation.

Will this work with different spur gear sizes?

Yes, it is compatible with standard TT02 spur and pinion combinations, but always set mesh and backlash after any spur gear change to prevent premature wear.

How should I verify the installation is correct?

Rotate the drivetrain by hand to confirm smooth engagement, then run a short low-speed test while listening for abnormal noise before full-power runs.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved