TAMIYA WR02/DT03T Blitzer Beetle Steering Knuckles Aluminum Upgrade - JR-WR201-GR by JAZRIDER  [JR-WR201-GR]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Green)
Price:
£6.84
Brand:
JAZRIDER
Model:
JR-WR201-GR
Condition:
Brand New
Available in shop
Write a review

Upgrade summary for TAMIYA front uprights

This aluminum front upright set is an RC-scale replacement part intended for use on TAMIYA WR02, DT03T and Blitzer Beetle chassis as indicated by the product name. Manufactured and finished in green, the uprights replace standard plastic steering knuckles to provide a firmer steering pivot and more consistent handling inputs.

Installation notes: the kit replaces the front upright assemblies and pairs with the existing steering links and hub hardware on compatible TAMIYA WR02/DT03T/Blitzer Beetle arrangements. During installation, check screw compatibility, tighten parts evenly, and verify steering travel and toe-in after final assembly.

Tuning role: aluminium uprights help keep spindle alignment under load, preserving toe and camber during dynamic cornering. Racers often choose aluminium uprights for more predictable turn-in and repeatable setup changes.

Should I change my toe or camber after fitting JR-WR201-GR?

Expect slightly altered feel; retake baseline measurements and adjust toe and camber incrementally. Start with your previous settings then tweak to account for the reduced spindle flex.

Are there any clearance issues to watch for with these uprights?

Verify wheel and hub clearances after installation, especially if you run wider tyres or aftermarket hubs. Confirm no contact with suspension arms or driveshafts throughout full suspension travel.

Will these uprights work with other TAMIYA variants?

They are intended for WR02, DT03T and Blitzer Beetle as stated; while other TAMIYA models may share similar geometry, always check fitment against your chassis dimensions before installing.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved