Tamiya WR02/DT03T/Blitzer Beetle Compatible Front Uprights - JR-WR201-BK by Jazrider  [JR-WR201-BK]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Black)
Price:
£6.84
Brand:
JAZRIDER
Model:
JR-WR201-BK
Condition:
Brand New
Available in shop
Write a review

Fitment and compatibility notes

This aluminum front upright set is produced as an aftermarket replacement for Tamiya WR02, DT03T and Blitzer Beetle front suspension assemblies, focusing on reduced knuckle deflection and steadier steering under load. It helps maintain steering geometry when driving on uneven terrain or at higher cornering loads.

To fit, remove the wheel hub and existing hardware, swap the uprights while reusing bearings and pins, then check kingpin alignment and steering geometry. No special tools are required beyond common hex drivers and pliers typically used for these Tamiya chassis.

When assessing compatibility on a modified chassis, double check hub spacing and any aftermarket hub adaptors to ensure there is no interference across the full range of suspension travel.

Compatibility

  • WR02
  • DT03T
  • Blitzer Beetle

Will these uprights work with modified hubs or wheel spacers?

They are sized for stock hub spacing; if you run aftermarket spacers or wider hubs, verify clearance and suspension travel to avoid rubbing or binding.

Are any geometry changes expected on lowered or raised setups?

Yes. Changes in ride height can alter kingpin angles and camber behavior, so recheck alignment when using non-stock ride heights.

Do these uprights affect servo load or steering link wear?

Stiffer uprights reduce deflection but can increase loads on steering links and the servo; ensure links and servo savers are in good condition and check for accelerated wear after fitting.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved