TAMIYA WT-01N Performance Wheelie Bar Aluminium WTN333R by GPM  [WTN333R]

Tamiya WT-01N Aluminium Wheelie Bar - 1set - GPM WTN333R
Price:
£14.79
Brand:
GPM
Model:
WTN333R
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Aluminium launch bar for WT-01N chassis

This aluminium wheelie bar is a replacement set designed for the TAMIYA WT-01N chassis. It is intended to manage rear lift under heavy acceleration and to reduce tip-back during straight-line launches.

As an aftermarket hop-up the design emphasises alloy stiffness and a precise mounting interface for the WT-01N rear bracket. It provides an effective way to tweak launch response without modifying motor or gearing.

Specifications

  • Item Wheelie bar, 1 pcs
  • Material Aluminium
  • Model Number WTN333R
  • Compatibility TAMIYA WT-01N

Install this aluminium bar when you need consistent rear lift control on WT-01N setups; always verify fastener security and clearance after installation.

Is the fit direct to WT-01N mounts?

Yes, it is designed for direct fit to the WT-01N rear mounting area but check alignment and tighten screws to the recommended torque.

Will the aluminium corrode in wet conditions?

Aluminium resists rust but keep exposed surfaces clean and dry where possible; remove grit and moisture after wet use to preserve finish.

Does this affect handling on corners?

The bar primarily alters straight-line tip-back; handling in corners is largely unchanged, though very aggressive setups may feel a small difference at transition.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved