TAMIYA XV-01 Compatible Front Knuckle Arms - JR-XV100-GU by Jazrider  [JR-XV100-GU]

Tamiya XV-01 Aluminum Front Knuckle Arms (Gun Metal)
Price:
£8.10
Brand:
JAZRIDER
Model:
JR-XV100-GU
Condition:
Brand New
Available in shop
Write a review

XV-01 steering knuckle replacement

This RC-scale aluminum front knuckle arm set is produced for compatibility with XV-01 chassis and is listed under the JR-XV100-GU model identifier. It is intended as an aftermarket replacement where users prefer alloy components to reduce steering deflection compared with the standard plastic knuckles.

The parts mount to the XV-01 steering assembly using the original bosses and hardware. Typical installation reuses pivot balls, spacers and bearings from the stock knuckles; check for any required spacer adjustments when combining with nonstandard hubs or drive shafts.

Aluminum knuckles influence steering feedback and can stabilise camber under load, which alters how the car reacts in high-speed transitions and cornering. After fitting, confirm toe and camber values and ensure the steering and suspension operate freely through their full range.

Are these knuckles fully compatible with stock XV-01 parts?

They are made to match XV-01 mounting geometry, so they are compatible with the stock steering components in most builds. Always compare mounting hole spacing and pivot locations if your chassis has been modified.

Will I need different bearings or seals?

Bearings and seals from the original knuckles typically transfer over. If you change hub offsets or use sealed bearings with different wall thicknesses, check axial clearance and securement before running.

How should I verify steering geometry after fitting?

After installation, measure toe and camber, cycle the steering through full lock and inspect for binding. Small toe or camber tweaks may be needed to restore original handling characteristics following the swap.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved