Team Losi Mini-T 2.0 14T Hardened Pinion for Drivetrain Service LM014T by GPM  [LM014T]

14T hardened pinion for Mini-T 2.0

This gearbox pinion is for Team Losi Mini-T 2.0 2WD cars and is catalogued as LM014T. It is manufactured in hardened 45# steel with a 2mm motor-bore and a 0.5mm tooth pitch, featuring 14 teeth. The part fits onto the motor shaft and transmits drive into the spur gear of the Mini-T 2.0 setup.

Key fitting notes and installation points:

• Design: hardened 45# steel pinion, 14T, 0.5mm pitch.
• Bore: 2mm centre hole to fit motors with a 2mm shaft; confirm shaft diameter before fitting.
• Installation: slide onto the motor shaft, set the gear mesh against the spur gear, tighten the set screw and verify axial alignment to prevent early failure.
• Tuning role: a 14T pinion alters the final drive ratio in comparison to other pinion sizes, affecting acceleration and top speed - pick the tooth count that matches driving conditions.
• Included items as supplied: pinion gear (1 pcs) and a 3x3 screw shaft (1 pcs).

Note: this is an aftermarket RC component for tuning or repair only and is not suitable for full-scale use.