TEAMPOWERS 48P Pinion Gear 26T TP-PG4826 - Performance Part  [TP-PG4826]

TEAMPOWERS Hard-Coated 48P Pinion Gear , 26T (TP-PG4826)
Price:
£4.05
Brand:
Team Powers
Model:
TP-PG4826
Condition:
Brand New
Write a review

Consistent Drive with TEAMPOWERS TP-PG4826

The TEAMPOWERS hard-coated 48P 26T pinion is aimed at modelers who prioritise consistent tooth engagement and longevity. Its finish and tight manufacturing tolerances help keep the power transfer reliable across many running sessions.

Core Advantages

  • Durability: Hard coating protects the gear profile against everyday wear and small abrasives.
  • Precision Engineering: Carefully cut teeth reduce play and help maintain smooth rotation under load.
  • Compatibility: Compatible with typical 48P motor pinion shafts when the shaft diameter and spline match the specification.

Installation and Use Notes

Install as part of a properly meshed gear set and recheck alignment after initial runs. This 26T pinion works well for consistent lap times and steady everyday performance whether you are tuning or running for fun.

Do I need a special tool to fit the pinion?

Basic hand tools are usually sufficient to fit the pinion. Use the correct size hex for the grub screw and ensure the shaft is clean and free of old threadlocker.

Will this pinion reduce the need for frequent replacements?

The hard-coated finish helps extend service life compared with uncoated alternatives, but replacement frequency depends on running conditions and maintenance.

What should I check after the first run?

After the first run, inspect tooth contact for even wear, confirm the pinion set screw is tight, and recheck mesh clearance to avoid early damage.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved