TL-01/GF-01/WR02 Steering C Hub, Red Anodized Aluminum - TAMIYA Compatible TL01-13306-RD by Jazrider  [TL01-13306-RD]

Steering C hub compatible with TAMIYA layouts

This RC-scale aluminum C hub is supplied as a direct replacement for the named TAMIYA chassis lines. It aligns with the TL-01, GF-01 and WR02 mounting points and comes in a red finish to match customised onroad rigs.

Replacing the factory plastic hub with a metal unit reduces deformation at the steering pivot and provides a firmer response under load. That change can make steering more predictable, especially when dialing in fine steering characteristics.

To install, remove the wheel and knuckle, transfer any bearings or inserts, attach the aluminum C hub using the original fasteners, and then check steering geometry before testing. Ordinary hobby hex drivers suffice and original torque settings should be observed to avoid misalignment.

The component is intended as an accessory for maintenance or gradual tuning; it does not replace systematic setup work and you should recheck toe and camber after fitting.