TRAXXAS GT4 TEC 2.0 Aluminium 7mm Hex Adapters Set GT010/12X7MM by GPM  [GT010/12X7MM]

7mm aluminium hex adapters for GT4 hubs

This aluminium hex adapter set is an aftermarket replacement suitable for TRAXXAS 4WD GT4 TEC 2.0 where accurate wheel-to-axle connection is required. The adapters are produced from 6061 T6 aluminium and dimensioned at 7mm hex thickness to suit wheel conversions that need a thicker mounting face than the original 6.8mm brake disk thickness.

The parts locate onto the axle to pass wheel loads while maintaining concentricity, aiding predictable handling and consistent wheel refitment. A tight fit on the axle reduces unwanted movement that can affect steering feedback and increase tyre wear during competitive or club running.

Kit hardware is supplied for immediate installation or maintenance:

• 2x10 steel pin - 4 pcs
• 2x5 stainless steel cap head screw - 4 pcs
• Hex adapters - 12 pcs

Installation note: the adapter face measures 7mm, so confirm clearance in relation to the original 6.8mm brake disk on GT4 TEC 2.0 hubs before finishing setup. These adapters act as a tuning option to adjust wheel offset and improve mechanical engagement without changing hub geometry.