TRAXXAS E-MAXX Front/Rear Drive Shafts 14pcs EMX2037S by GPM  [EMX2037S]

Front and rear drive shafts for E-MAXX

This 14 piece shaft set is an aftermarket drivetrain replacement for TRAXXAS E-MAXX vehicles. The components pair a 6061 T6 aluminium shaft body with #45 steel CVD heads, aiming to reduce rotating mass while preserving strength at the drive interfaces. Lower shaft weight can reduce drivetrain inertia and may modestly improve battery run time and decrease transmission load under heavy use.

Compatibility and fit: front shafts are 85mm and rear shafts are 132mm, matching common E-MAXX configurations. Steel CVD ends are placed where wear is most likely, engaging dogbones or drive cups, while the aluminium bodies cut overall weight. The set also supplies the small installation hardware usually required.

Fit this kit when replacing worn original shafts or when you want to tune the rotating mass on an E-MAXX. Confirm spline engagement, check clearances, and run a short test to ensure secure operation.