TRAXXAS MAXX CVD Drive Shaft Set (+2mm Offset) TXMS123AHEX by GPM  [TXMS123AHEX]

Performance-minded adjustable CVDs for MAXX

This 10pcs drive shaft set is an aftermarket upgrade for TRAXXAS MAXX Monster Truck platforms, suitable for use at the front or rear drive shafts and wheel mounting points. The kit replaces a traditional cross-head joint with a constant velocity swing joint to improve torque transfer under load while keeping rotating mass low.

Components combine hardened steel joints with a 6061-T6 aluminium body and a thicker axle section increased from 6mm to 8mm, boosting torsional strength without a large weight increase. The hex adapter uses a claw-style engagement and the pinhole was removed to give a firmer wheel hex interface and add 2mm track per side.

Adjustability allows careful tuning of driveline alignment and suspension geometry. Bearings and shims sized for the larger axle are included so additional bearing purchases are not typically required.

Install this set when you want improved driveline durability and a modest track increase for steadier high-speed tracking; always check wheel hex and bearing clearances during setup.