TRAXXAS MAXX Front Ring & Pinion Replacement TXMS1200FS by GPM  [TXMS1200FS]

TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS
Price:
£32.47
Brand:
GPM
Model:
TXMS1200FS
GTIN:
4894538334517
Condition:
Brand New
Write a review
alt="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS" title="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS"
alt="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS" title="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS"
alt="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS" title="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS"

Front ring and pinion replacement

This front differential ring and pinion set is supplied for the TRAXXAS MAXX and constructed from hardened steel #45. These gears are used to lower backlash and improve engagement between teeth when the drivetrain is under load.

The set suits hobbyists carrying out maintenance or tuning on MAXX drivetrains who want firmer gear engagement and steadier power flow from the motor through the differential. Fitting requires access to the front differential case and common RC tools.

Packing includes

  • Ring Gear - 1 pcs
  • Pinion Gear - 1 pcs

Original Name / Part No:

Improve the transmission of power in the differential case.

Specifications

  • Item Front differential ring & pinion gear set
  • Material Hardened steel #45
  • Model Number TXMS1200FS
  • Quantity 2 pcs
  • Compatibility TRAXXAS MAXX

Opt for this gear set when replacing worn front gears or upgrading for durability; always verify correct mesh and inspect after a short initial run to confirm fitment.

This item is compatible with

  • TRAXXAS-1/10 MAXX MONSTER TRUCK-89076-4
  • MAXX W/WIDEMAXX MONSTER TRUCK-89086-4

Are these a direct swap for the stock parts?

They are designed for the TRAXXAS MAXX but you should confirm your differential uses the same ring and pinion dimensions prior to installation.

Which checks are recommended after fitting?

After fitting, run the vehicle slowly to listen for abnormal noise, then recheck the gear mesh and fastener torque after a few short runs.

Will these gears handle higher loads?

Hardened steel #45 offers better wear resistance and helps the tooth profile resist deformation under heavier loads, which aids mesh stability.

Any routine maintenance advice?

Inspect teeth for uneven wear periodically, confirm mesh settings, and retorque screws after initial break-in runs to maintain reliable performance.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved