Traxxas Revo 36T Spur Gear Delrin RE-028 by 3Racing  [RE-028]

Traxxas Revo Delrin Spur Gear 36T - 3RACING RE-028
Price:
£5.04
Brand:
3Racing
Model:
RE-028
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

36 Tooth Delrin Spur for Traxxas Revo

This 36-tooth Delrin spur gear is intended as a direct replacement or upgrade for use in Traxxas Revo transmissions. It suits maintenance tasks, tuning sessions and routine spur replacement where a low-wear, low-friction gear material is preferred.

Delrin, an acetal engineering plastic, is selected for dimensional stability and reduced friction versus some other polymers. In operation the spur conveys motor pinion input through the gearbox, so correct gear mesh and well-supported bearings are important to avoid premature wear.

Installation guidance: clean contact areas, confirm backlash and ensure the spur seats squarely on the Revo spur hub or mounting plate. Carry out a short, low-load shakedown run after fitting to check engagement before regular running.

Will this replace the stock Revo spur directly?

It is made for Revo spur locations that use a 36T gear; confirm tooth count and hub fit on your vehicle prior to purchase.

What should I inspect before first run?

Verify mesh, bearing condition and shaft alignment, then perform a low-torque test to ensure smooth engagement and quiet operation.

How often to inspect the spur?

Inspect during routine service or after heavy use; replace if you see tooth wear, cracking or persistent noise despite correct mesh.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved