Traxxas Revo Rear Rocker Arm 90T Replacement - RE-012/S by 3Racing  [RE-012/S]

Product summary for Revo rocker

This rear rocker arm suits Traxxas Revo models and is supplied as RE-012/S. It is intended as a direct replacement for the stock rear rocker to re-establish suspension geometry and support setup changes without moving other linkage points.

The 90T marking identifies the tooth profile used in the Revo rear suspension, and the silver finish makes matching simple on most builds. Install this part when the factory rocker becomes worn or bent, or when adjusting leverage to alter handling characteristics.

Installers familiar with Revo service should find the swap straightforward: remove the rear rocker, migrate bearings or pins if still serviceable, and secure the new arm using factory torque settings and threadlocker where recommended. After fitment, check hinge pin alignment and suspension droop to ensure correct geometry.

Choose this rocker to maintain reliable rear suspension performance on Revo chassis and carry out normal post-installation checks.