Traxxas Revo Steering Saver Plate RE-033/S by 3Racing  [RE-033/S]

Revo Saver Mount Summary

This RC-scale saver plate is supplied as a direct-fit accessory for the Traxxas Revo chassis, intended to hold a steering saver assembly while maintaining the vehicle's original mounting geometry.

The plate positions the steering saver so that shock loads and sudden impacts are taken by the saver instead of the servo and principal steering links, helping to preserve steering feedback during hard use or extended sessions. The silver appearance matches many common Revo trims.

Installation follows a simple replacement procedure for experienced modellers: the unit swaps in for the stock piece using the chassis factory points and, where applicable, reuses the original screws and linkage hardware. Typical RC hex drivers and hand tools are sufficient.

For setup and tuning, fitting this aftermarket plate lets you try different saver units and link arrangements to control how much impact is absorbed before the servo registers the load.