TRAXXAS Rustler 4X4 VXL Rear Stub Axle Carriers 7075 Alloy RUS4022N by GPM  [RUS4022N]

7075 Alloy Rear Stub Axle Carriers Overview

This aluminium rear stub axle carrier set is an aftermarket replacement for specified TRAXXAS 1/10 4x4 platforms. The carriers are machined from 7075 alloy to offer a balance of lower weight and stronger tensile properties, with geometry intended to stabilise the rear lower and upper arm junctions at the axle interface.

The design locates 5x13x4 bearings in a tightened seat to reduce axial and radial play. Reduced bearing gap helps the rear wheel assemblies rotate with steadier alignment, which supports more predictable rear-wheel behaviour under throttle, cornering and varying loads.

Installation notes: these carriers are direct-replacement components for the TRAXXAS models listed and will generally reuse the original fasteners and bearings where suitable. On reassembly verify bearing orientation and preload, and confirm clearance to driveshafts and suspension links before final tightening.

These carriers restore tighter bearing alignment and cut rear-end play on compatible TRAXXAS 1/10 4x4 models, making them a reliable aluminium replacement for worn plastic housings.