TRAXXAS Rustler VXL Front Arm Bulk RUS008 alloy replacement by GPM  [RUS008]

Rigid alloy front bulk for Rustler VXL

This alloy front arm bulk is an aftermarket replacement tailored for TRAXXAS 1/10 Rustler VXL models, intended to substitute the standard plastic bulkheads. As a front suspension pivot component it gives a more rigid mounting point that affects steering geometry, toe stability and camber control when under load.

Fitting is a standard maintenance job: remove the front suspension, exchange the bulk units, check the alignment of pin and bearing seats and reassemble, using thread locker where recommended. No specialist equipment is typically required beyond hex drivers and a basic spanner set, but verify fitment before completing assembly.

When tuning, the alloy bulk reduces pivot movement and can make steering response more predictable during corner entry and mid-corner phases. This component is intended for 1/10 Rustler VXL repair and setup work as specified.

Fit the RUS008 alloy bulk to renew worn front bulkheads or to create a firmer platform for suspension tuning on TRAXXAS Rustler VXL cars.