TRAXXAS Slash 4x4 CVD Screw Pins Front and Rear Replacement SSLA1277RHP by GPM  [SSLA1277RHP]

Front/rear CVD screw pin replacement for Slash 4x4

This aftermarket two-piece set is intended to stabilise the front and rear CVD drive shaft joints on TRAXXAS Slash 4x4 models. It is supplied as a 2 pcs replacement set to match the original screw-pin role in the Slash F/R CVD yoke.

The pins retain axial and rotational position within the CVD assembly, reducing end float and helping ensure steady driveshaft engagement during load. Use them where original pins are worn, bent, or allow excess movement that affects driveline behaviour.

Installation follows a simple procedure for those experienced with CVD maintenance: remove the assembly, swap the worn pin for the replacement, and reassemble using the vehicle's original fastening method. This is an RC-scale replacement designed to fit the Slash F/R CVD interfaces identified in the product title.

Workshop tip: view these as a straightforward reliability part rather than a performance upgrade; they help preserve consistent power transfer by keeping CVD components correctly positioned under stress.