TRAXXAS Slash 4x4 Steering Link Turnbuckles SSLA160ST by GPM  [SSLA160ST]

Steering link turnbuckles for Slash 4x4

This 3pcs set of spring steel turnbuckles with alloy ball ends is supplied for TRAXXAS Slash 4x4 1/10 models as a dependable replacement or upgrade for steering and suspension linkages. The spring steel shafts offer better straightening resistance and the alloy ball ends ensure stable articulation at the ball sockets.

To fit, remove the old turnbuckle, confirm thread directions, and thread the replacement into the existing ball cups until the preferred length and toe settings are achieved. Keep original measurements and make adjustments in small steps to preserve correct alignment and drivability.

These turnbuckles are handy for tuning since they provide fine length control for toe and steering angle and a sturdy connection that holds up under impact stress. Use them when replacing worn ball ends or when you need repeatable setup changes for handling balance.

A practical upgrade to keep steering geometry accurate on the Slash 4x4 platform, supplied as a three-piece set for targeted maintenance or improvements.