TRAXXAS Slash 4x4 Wheel Hex Adaptor SLA010/6MM 6mm by GPM  [SLA010/6MM]

6mm aluminium hex adaptor for Slash 4x4 hubs

This wheel hex adaptor is supplied for the TRAXXAS Slash 4x4 and comes as a set of four. The SLA010/6MM is a 6mm thick aluminium hex intended to replace or alter the standard wheel hex seating to change wheel offset and wheel positioning.

Installed instead of the stock hex, the adaptor delivers a solid contact surface between hub and wheel to keep alignment steady during use and to allow measured adjustments to track width and inset. Aluminium construction helps maintain dimensional stability under typical hobby stresses.

Use the adaptor when a simple mechanical adjustment to wheel positioning is required for setup or to restore correct fitment after wear. The item is for RC-scale hobby use only and specified for the Slash 4x4 model named above.