TRAXXAS Slash Rear CVD Drive Shafts 304 Stainless Joints with 6061-T6 Aluminium - SSLA1277RHA by GPM  [SSLA1277RHA]

Rear constant velocity drive shaft for TRAXXAS Slash

This aftermarket rear CVD drive shaft set is intended for TRAXXAS Slash platforms and built for 1/10 drivetrain duty. The configuration uses stainless steel 304 for the moving joint parts and 6061-T6 aluminium for the shaft bodies to strike a balance between corrosion resistance and lightweight strength.

Design highlights centre on protection and longevity. The joint assemblies are largely enclosed to reduce exposure to stones and grit, while silicone O-rings at the coupling reduce shock passed to the CVD during hard landings. The anodised 6061-T6 bodies are produced with a slightly greater thickness than stock to deliver longer service life without impairing fitment.

Fitting guidance: intended for rear gearbox-to-wheel installation on the Slash variants listed in the compatibility box. The kit supplies optional 3mm steel hex shims to fine tune wheel hex engagement if required. Always verify wheel hex spacing and tighten fasteners to the vehicle maker's torque recommendations. For RC 1/10 scale use only.

Select this set for a corrosion-resistant rear CVD that emphasises joint protection and slightly thicker shafts for extended life; check compatibility with your wheel hex and gearbox before installing.