TRAXXAS Telluride 4x4 Aluminium Main Shaft with Hardened Ends TEL025 by GPM  [TEL025]

Sturdy aluminium main shaft replacement

This aluminium main shaft with hardened steel end fittings is an aftermarket replacement tailored for TRAXXAS Telluride 4x4 RC models. The aluminium centre section combined with hardened steel terminations directs wear to the contact points with gears and bearings, offering a pragmatic durability upgrade for weekend trail and off-road use.

Delivered as a single pcs item, the shaft is intended for the Telluride 4x4 platform detailed in the specifications. Fitting normally involves removing the gearbox or axle housing cover to extract the original shaft, swapping the parts, and checking gear mesh and bearing alignment. Expect to make small spur/pinion or bearing preload adjustments to achieve a smooth drivetrain after installation.

On installation ensure the steel ends seat properly in their bearings and that there is no excessive axial play. Carry out a brief, low-load test run to confirm smooth operation before full use. Routine checks of the hardened ends and nearby bearings will highlight wear early and reduce the risk of gear damage.

Use this shaft to replace worn drivetrain parts or to add a modest durability upgrade to TRAXXAS Telluride 4x4 models; always verify fit and mesh when fitting.