TRAXXAS Tmaxx 3.3 / Tmaxx 1.1 Front Bulk Head Side Plate Set Alloy TMX1012 by GPM  [TMX1012]

Aftermarket alloy side plates for the Tmaxx front bulk head

This alloy front bulk head side plate set is an aftermarket replacement for TRAXXAS Tmaxx 3.3 and Tmaxx 1.1 models. The components act as the left and right side plates of the front bulk head assembly and include the mounting screws, pins, lock nuts and E-clips specified in the product name. The parts are intended for model use and install into the front chassis in place of the stock plates.

Fitment and purpose: these plates secure suspension mounts and linkages on the front bulk head and therefore influence steering geometry and suspension pickup locations. When replacing a damaged original or opting for alloy durability, confirm the suspension pin alignment and steering link clearances before completing the assembly.

Installation advice: remove the front clip and any body mounts, support the front end to avoid moving the gearbox or motor mount, then either reuse original pins and spacers or fit the supplied hardware. Tighten lock nuts progressively to avoid thread strain and use E-clips where required to retain pins. After fitting, check full suspension travel and steering operation.

A straightforward alloy upgrade for hobbyists wanting stronger front-end components; always confirm part alignment and hardware on receipt and after fitting.