TRAXXAS T-Maxx Alloy Servo Bracket with 4mm Steel Handle STMX2112 by GPM  [STMX2112]

This alloy servo bracket and 4mm steel handle are supplied as a single set to replace the stock plastic mount on TRAXXAS 1/10 T-Maxx models. The upgrade increases rigidity at the servo interface to better withstand demanding off-road use.

Fitting the alloy bracket in place of the original helps reduce flex at the servo mount points, improving steering consistency when fitting higher-torque servos or when running more aggressive suspension geometry. The 4mm steel arm offers a stronger transmission of servo output to the steering linkage, which assists precise steering on uneven ground.

Fitment advice: this is an aftermarket part for TRAXXAS T-Maxx 1/10 variants; inspect and reuse stock screws where appropriate, and confirm that hole alignment and servo spline engagement are correct before locking down. Older or heavily modified chassis may need minor shimming to achieve a flush, secure fit. Use thread locker on metal fastenings to prevent loosening.

Setup guidance: after installation, re-evaluate steering endpoints and subtrim since the reduced flex changes mechanical leverage. This component is designed to work alongside correct suspension and electronic settings rather than replace tuning work.