TRAXXAS Tmaxx Rear Bulk Head Side Plate Set TMX1013 for Chassis Upgrade by GPM  [TMX1013]

Precision alloy rear bulk head side plates for Tmaxx

This alloy rear bulk head side plate set is produced for TRAXXAS Tmaxx machines and carries model TMX1013. It replaces the OEM rear bulk head side panels and includes the screws, pins, collars, lock nuts and E-clips referenced in the product title to make installation straightforward.

Manufactured from aluminum alloy, the plates deliver stronger rear-end support than stock plastic components while remaining suitable for everyday off-road and bashing activities. They are intended as a chassis stiffening and tuning upgrade rather than a substitute for suspension or gearbox parts.

Fitment advice and tuning considerations:

• Compatibility: designed for TRAXXAS Tmaxx 3.3 and Tmaxx 1.1 variants; always confirm the rear bulk head mounting geometry before fitting.
• Fitment: direct-replacement side plates that use the supplied hardware; remove the rear bulk head assembly and fit the new plates following standard procedures.
• Tuning effect: alloy plates raise rear stiffness, improving cornering accuracy and throttle feel while slightly reducing compliance over rough ground.
• Maintenance: check and retorque fasteners and verify E-clip seating after initial runs and during routine checks.

For racers and hobbyists looking to replace worn components or tune chassis stiffness, this alloy rear bulk head side plate set is a dependable aftermarket choice for Tmaxx 3.3 and 1.1 platforms and includes the hardware required for a neat installation.