Traxxas TRX-4 Stainless Steel Front/Rear Bumper Mount Protector JR-TRX442 by JAZRIDER  [JR-TRX442]

Traxxas TRX-4 Stainless Steel Front/Rear Chassis Bumper Mount Protector Guard Ver.2 (1pc)
Price:
£5.37
Brand:
JAZRIDER
Model:
JR-TRX442
Condition:
Brand New
Available in shop
Write a review

Bumper mount reinforcement overview

This stainless steel protector is an RC-scale accessory crafted to reinforce the front and rear bumper mount areas on the Traxxas TRX-4 chassis. It provides a targeted metal shield at the bumper mounting points to limit direct wear to the chassis surface during scale crawling and trail work.

Design and fitment: the item is specified for the Traxxas TRX-4 chassis and is shaped to align with the bumper mount zone and the chassis' factory mounting holes. Confirm your TRX-4 variant and bumper layout before fitting to make sure there is adequate clearance with any aftermarket bumpers or accessories.

Application: the guard fits at the chassis bumper mount location and acts as a sacrificial plate to preserve chassis attachment geometry when swapping to heavier scale bumpers or when operating in terrain where contact is likely.

Can I use this with an aftermarket winch bumper?

It can be used with many aftermarket bumpers, but because winch bumpers vary in mount layout and clearance, you should compare the bumper footprint to your TRX-4 mounting points and confirm no interference before fitting.

Does fitting require trimming or modification?

The protector is formed to match stock TRX-4 mount locations; most fits require no trimming. If your bumper or accessories alter mount geometry, minor trimming or re-drilling of non-structural trim pieces may be necessary.

Should I check clearance after installation?

Yes. After fitting, cycle the suspension and steer through full travel to confirm the guard does not contact other components and that bumper clearance is acceptable under dynamic conditions.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved