TRX4 Steering and Suspension Ball Ends 12pc TRX4160A/BE by GPM  [TRX4160A/BE]

Spare ball ends for TRX4 linkage joints

This twelve-piece set supplies plastic ball ends intended as replacement units for the TRX4160A assembly found on certain TRAXXAS TRX4 vehicles. They are produced as scale RC parts and are listed as replacements for #TRX4160A only, not as Traxxas original parts.

Install these at the locations where the TRX4160A assembly secures ball joints to recover articulation and permit steering or suspension geometry adjustment without changing the entire linkage. The quantity included is enough for multiple joints or a complete axle service on crawler machines.

Installation advice: remove the worn ball ends from the TRX4160A sockets, press the new ball ends into position, then verify smooth movement and a secure fit. After initial use, inspect for play and replace any item that shows deterioration.