TRAXXAS TRX6 Front Center Rear CVD Replacement Aluminium/Steel - TRX6037SA by GPM  [TRX6037SA]

Steel and 6061-T6 aluminium CVD shafts tailored to TRX6

This 21pcs drive shaft set is an aftermarket replacement and upgrade kit made for the TRAXXAS TRX6 MERCEDES-BENZ 88096-4 scale crawler platform, identified as model TRX6037SA. The set mixes 6061-T6 aluminium with high-strength steel to balance rotational mass and component longevity across the front, center and rear drive assemblies.

The parts are designed to transmit torque from the gearbox and motor to the axle outputs. The mixed-material scheme is intended to deliver improved stiffness where needed while keeping rotating weight low for precise low-speed crawling control.

Install this kit to replace worn CVD shafts or to tune drivetrain behaviour for heavier loads. The 21pcs package is supplied with the small stainless screw pins and silicone rings required for fitting to the compatible TRX6 configurations.

For scale crawler drivers seeking solid replacement parts, the TRX6037SA kit targets the primary wear points across the TRX6 front, center and rear CVDs while leaving the gearbox and motor unchanged.