TRAXXAS Unlimited Desert Racer Upgraded Front CVD UDR096FS by GPM  [UDR096FS]

Upgraded front CVD for Unlimited Desert Racer

This aftermarket front CVD kit is intended for TRAXXAS Unlimited Desert Racer vehicles to replace standard dogbones and improve front driveline durability. Torque is transferred to the front wheels via an SST joint paired with a hardened steel body, aiming for a firmer response without altering the original driveline layout.

The package supplies two front CVD halves meant to pair with existing dogbones and driveline components. The extra duty dimension range spans 4.5mm to 6.5mm and the midpoint dogbone length is set at 96mm to maintain the Unlimited Desert Racer's stock geometry.

Installation follows standard CVD replacement procedures: remove the stock dogbones, fit the CVD halves to axle and hub points, secure SST joint fasteners, then check spline engagement and suspension travel for any interference. Apply thread locker where needed and recheck after a brief test drive.

A practical upgrade for drivers wanting increased front driveline rigidity and reduced wear while keeping original vehicle geometry.