TRAXXAS X-Maxx +1mm Aluminium Hex Claw for Wheels TXM006/+1 by GPM  [TXM006/+1]

Wheel hex claw for X-Maxx fitment

This pair of aluminium wheel hex claws is made for TRAXXAS 1/8 X-Maxx installations and supplies a +1mm offset to alter wheel engagement. They serve as direct replacement hexes that interface with standard X-Maxx hub assemblies while keeping the upgrade focused on wheel position and clamp reliability.

Use the +1mm claw when a modest outward shift will clear tyre rub, help seat aftermarket rims, or permit small track width adjustments to tune handling. Aluminium construction improves dimensional stability and wear resistance versus common plastic hexes, supporting consistent wheel mounting during demanding runs.

Installation follows familiar wheel removal and reinstallation steps: take off the wheel and existing hex, fit the aluminium claw to the hub, confirm it is seated flush, then refit and secure the wheel per original instructions. Run a short test to confirm no rub or loosening before regular running.

For competitive hobbyists and weekend tuners of TRAXXAS X-Maxx, the +1mm aluminium hex claw is a practical upgrade to adjust wheel fit and increase wear resilience without changing hubs.