Traxxas XO-1 Rear CVD Shaft Replacement 304 SS Joints & 6061 T6 - SXO1277RHA by GPM  [SXO1277RHA]

Sturdy rear CVD shafts tailored for Traxxas XO-1

This rear CVD drive shaft kit is made for Traxxas XO-1 vehicles, using 304 stainless steel for the axle joints and 6061 T6 aluminium for the shaft bodies to reduce rotating mass and improve strength versus stock plastic components.

The joint sits recessed inside the housing and is protected by silicone O-rings to limit shock transfer during impacts or landings. Components are produced slightly thicker than factory parts to extend lifespan under demanding driving conditions.

Aluminium bodies are available anodised in multiple colours and the assembly fits as a direct hop-up replacement for XO-1 owners seeking improved joint protection and longer service life without modifying gearbox geometry.

Fit these as rear replacements on XO-1 setups to reduce joint wear and boost impact resilience; always verify clearance and correct orientation after install.