TRAXXAS XRT 8S 7075-T6 CNC Chassis Plate 6mm XRT016 by GPM  [XRT016]

XRT 8S Undertray Reinforcement

This aftermarket aluminium chassis plate is intended for the TRAXXAS XRT 8S 1/6 scale 4WD platform and for RC use only. Manufactured from 7075-T6 and CNC formed to a 6.0mm nominal thickness, the plate stiffens the stock chassis and enhances abrasion resistance at critical mounting points.

Role and mounting: the plate fits below the front, centre and rear chassis areas to bind the rails together, cutting flex under high load and offering extra protection from impacts and underside wear during offroad use. It is a structural upgrade aimed at improving handling consistency and establishing a firmer setup baseline.

Fitting guidance: supplied with flat head screws for attachment; follow the factory mounting points and use moderate hand torque to prevent thread damage. The plate is made for direct fit to the listed TRAXXAS model and does not require trimming when installed on compatible chassis.

For model builders running the TRAXXAS XRT 8S, this 7075-T6 chassis plate gives a bolt-on increase in torsional stiffness and abrasion protection while keeping original mounting geometry unchanged.