This 16-piece accessory set suits TRX-4 pattern shells and carries the designation TRX4ZSP10. The handles are 3D printed in PLA to provide a smooth tactile finish and realistic scale styling for crawler enthusiasts.
Hardware supplied: 12pcs of M1.2x3 stainless steel screws to secure the handles to model body shells. Screws are intended strictly for shell mounting and complement the printed parts.
Fitment advice: drill or ream small pilot holes in the shell, position each handle, then fasten using the supplied M1.2x3 screws. Do not over-tighten to avoid stressing thin shell material.
Use these handles to refine the scale appearance of a TRX-4 crawler body; they are decorative model parts and not for practical vehicle use.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved