This aluminium rear suspension arm mount and gearbox support is produced as an RC hop-up for the B8 rear assembly points on the Tamiya 1/10 buggy chassis shown below. It increases rear mounting stiffness and supplies a flat, stable area around the gearbox to minimise flex when the vehicle is loaded, making small suspension adjustments more repeatable.
As a direct replacement for the B8 mount locations, the component preserves the original layout while changing the local stiffness. It is ideal where a firmer rear end is required for handling balance or where gearbox stiffness is important. Installation involves accessing the B8 rear mount area and partial removal of the rear suspension subassembly; check fitment carefully prior to final tightening.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
