Xenon Racing GPR48-070 Club Race 70T Spur Gear  [GPR48-070]

Price:
£5.31
Brand:
Xenon Racing
Model:
GPR48-070
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Performance-Oriented 70 Tooth Spur

The Xenon Racing GPR48-070 is a 70 tooth spur gear intended for 1/10 scale touring car drivetrains. Its 48 pitch tooth form supports consistent engagement, helping maintain smooth torque delivery during racing and practice sessions.

Optimise Your Gearing

Using a 70T spur gives finer steps when adjusting overall ratio, allowing drivers to tune acceleration and top speed with precision. It is compatible with standard 48 pitch pinions and gearboxes used in many touring car setups.

Reliable Fit and Finish

Made to withstand regular use, this spur gear is a sensible upgrade or replacement for racers and hobbyists alike. Its broad fitment range across touring car models makes it a practical addition to any parts stash.

Will the GPR48-070 work with my current pinion?

As long as your pinion is 48 pitch and the gearbox accepts a 70T spur, it will mesh correctly. Always check pinion tooth count and pitch before fitting.

What checks should I do after installation?

Verify correct mesh, ensure there is no binding, and run the drivetrain at low speed to listen for abnormal noise before full power runs. Adjust as needed.

Is this spur suitable for high torque motors?

The spur is built for routine and racing use, but ensure your whole drivetrain is rated for the motor's torque. Correct mesh and maintenance help prevent premature wear.

How often should I inspect the spur gear?

Check the gear teeth periodically, especially after knocks or heavy running. Regular inspection prevents small issues turning into gearbox failures.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved