Xenon Racing PPR64-35 Race-Grade 64P Pinion  [PPR64-35]

Xenon Racing Xenon Pinion Gear 64P/35T PPR64-35
Price:
£6.74
Brand:
Xenon Racing
Model:
PPR64-35
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Race-Grade Pinion for Precise Ratio Control

When setup accuracy counts, the Xenon Racing PPR64-35 offers a 64-pitch pinion with 35 teeth to help you find the best gear balance. Its 64P profile makes small, predictable changes in drivetrain ratios for better lap consistency and motor management.

Control and Longevity

The Xenon PPR64-35 aims for dependable tooth contact and steady performance throughout repeated sessions. The finer pitch assists in achieving discreet tuning steps without dramatic shifts in torque or top speed.

Best Practices and Suitability

This pinion is intended for any vehicle that calls for a 64P pinion and pairs with matching spur gears. It is a straightforward replacement or upgrade for racers focused on drivetrain precision across varied surfaces.

How precise are gear changes with a 64P pinion like the PPR64-35?

A 64P pitch gives finer increments between tooth counts, so moving one tooth up or down results in modest, controllable shifts ideal for tuning corner entry and exit behaviour.

Will this pinion work on both touring and buggy setups?

Yes. If the drivetrain specifies 64P, the PPR64-35 can be used on touring cars, buggies, and similar platforms, assuming motor spline and clearance match your chassis.

What checks should I make after installing a new pinion?

After installation, set proper mesh, run in briefly at low power to seat teeth, then recheck for noise and tight spots. Regular inspection helps catch early wear.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved