Xenon Racing PPR64-39 Club Race 64P/39T Pinion  [PPR64-39]

Xenon Racing Xenon Pinion Gear 64P/39T PPR64-39
Price:
£6.74
Brand:
Xenon Racing
Model:
PPR64-39
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Optimise Gear Mesh with Xenon Racing PPR64-39

The Xenon Racing PPR64-39 pinion gear features a 64-pitch, 39-tooth layout developed to improve power transfer in RC models. It is aimed at users who want predictable engagement and cleaner acceleration from their drivetrain. The pinion is a logical upgrade for maintaining smooth gear operation on the track.

Advantages of the 64P/39T Choice

The 64P/39T format provides fine tooth contact for accurate power delivery and reduced vibration. This balance helps preserve motor efficiency and gives a consistent feel when accelerating out of corners or under steady throttle.

Installation Notes for Best Results

Install the pinion into compatible gearboxes and verify proper mesh with your spur. Tighten fastenings securely and check alignment after a few runs to prevent premature wear. Correct setup is essential for long term reliability whether you run on-road or light off-road.

Will the Xenon Racing PPR64-39 suit on-road racing models?

Yes, many on-road racers use this pinion for its precise tooth engagement, but always confirm your spur gear pitch matches to avoid poor mesh.

How should I set gear mesh for best life?

Start with a small gap to avoid tight binding, run the motor slowly while adjusting, and then secure the pinion once you have smooth, quiet engagement under load.

Are there signs the pinion needs replacing?

Look for rounded or chipped teeth, unusual noise, or slipping under load. If any of these appear, replace the pinion to protect the rest of the drivetrain.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved