XRAY 303089 T3 Rear Graphite Shock Tower 3.0mm Classic  [XR-303089]

XRAY 303089 T3 Shock Tower Rear 3.0mm Graphite
Price:
£31.72
Brand:
XRAY
Model:
XR-303089
Condition:
Brand New
Write a review

Classic T3 Rear Tower in 3.0mm Graphite

The XRAY 303089 rear shock tower serves as a replacement part for vintage T3 RC models. Made from tough 3.0mm graphite, it helps restore chassis stiffness and preserves the original suspension geometry for reliable on-track feel.

Tailored Support for Vintage T Series

This component is produced to maintain correct shock mounting and rear end behaviour. The 3.0mm graphite material boosts structural integrity while remaining light, letting you keep existing shock and spring choices without excess mass.

Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
After fitting, verify that mounting screws are seated and the rear geometry aligns with your setup sheet. Run a short test to confirm suspension movement is free and predictable.
Yes, the tower works with a range of shock units. Make sure shock eyelet spacing and mounting hardware match to avoid binding.
Keep mounting areas clean and inspect for hairline cracks after heavy impacts. Replace the tower if any structural damage is visible to maintain safe handling.
No adaptors are typically needed for standard T3 setups. Use the original fasteners and confirm hole alignment before tightening fully.
The 3.0mm graphite tower suits a variety of surfaces, from smooth carpet to outdoor asphalt. Adjust shock settings to match grip levels for the best performance.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved